Technical support for non-supported devices is not available. IntelliTouch ScreenLogic can only be used with the provided ScreenLogic PDA, Tablet, and in-wall Touch Screen devices. Proceed to “ Connect to the Personality Board,” page 25.Use the following information to resolve general ScreenLogic operation issues.īefore contacting Pentair Water Technical Support, please note that Technical Support personnel can only assist with relevant questions regarding IntelliTouch ScreenLogic hardware and software. Insert the screw terminal connector onto the pins on the adapter circuit board. The pin numbers and wire color codes are:Ĥ. Make sure to match the color coding of the wires with the pin colors indicated on the adapter label. Insert the four wires into the connector screw terminals. Strip back the four cable conductors ¼ inch. Grasp the Protocol adapter with one hand, and with your other hand gently pull outward on screw terminalģ. Ideally, both devices should be located near the home owners DSL or Cable modem.Ģ. Place the adapter in a dry area near the wireless router. Connect the Four-Wire Cable: Run a four conductor cable (22 AWG UL approved) from the LoadĬenter or Power Center location to the adapter. This avoids having to run a separate four wire from the Load Center to the Protocol adapter.ġ. Note: Existing Indoor Control Panel - If there is an existing IntelliTouch Indoor Control Panel, you can tap directly into the wire in the home or pig tail off the connector in the Indoor Control Panel. For wireless router location requirement, refer to “ScreenLogic Location Requirements,” page 17. If the wireless router is too far from the pool area, then you may need to move the wireless router closer to the pool area by running an Ethernet cable from the DSL/Cable Modem connection out to the Protocol adapter and wireless router.

Protocol Adapter Location: The IntelliTouch wireless router and Protocol adapter should be located inside in a dry environment, preferably near the home owners DSL/Cable modem. Before connecting the cable to the adapter, first determine the length of cable required for the connection. The IntelliTouch ScreenLogic Protocol adapter is connected to the Personality board located in the Load Center or Power Center via a four-wire cable.

Pentair protocol adapter manual